Because of their flush-mount design, installation only requires a tiny 3/16″ hole in your transom. Many competing lights require a larger (several inch diameter) hole for mounting, creating potential structural weakness, leakage, and other concerns.

Installation is easy; simply pass the power wire through a tiny 3/16” hole in the transom and route it to the power source (power regulator).

Fill up all holes with marine grade underwater sealant, we recommend using 3M™ 5200 (as well as the cup around the wire on the light) and fasten the light to your boat using the included stainless steel screws.

Frequently Asked Questions

“Can I keep these lights on out of the water?”

The lights should not be turned on if the boat is out of the water. The water acts as a cooling feature on the lights.

“Do the multicolor color lights come with a DMX controller?”

Yes, the DMX controller is included with the purchase of Multicolor lights.

“How many lights can I connect to the DMX controller?”

3.

“My Dual Color lights are out of sync, how do I sync them?”

Allow the lights to be turned off for 3 minutes. The Dual color lights will automatically reset to White after three minutes off.

“Can I connect more than three multicolor lights on my boat?”

Yes. If more than three multicolor lights are installed on a boat, a slave DMX controller will be included which will allow more than 3 lights to be synced together. 

“Can I high pressure clean the lights?”

The lights should never be pressure cleaned. Doing so could break the seal of the light and cause water intrusion.

“Do the lights come as a pair?”

All lights are sold per light.